DirDirect :: Undersuits & Heating Systems :: Made to Measure Undersuits :: Santi BZ400 Heated Undersuit (Made to Measure)

Santi BZ400 Heated Undersuit (Made to Measure)

Santi BZ400 Heated Undersuit (Made to Measure)
Santi Heated Undersuit Santi Heated Undersuit Santi Heated Undersuit

The made to measure version of the Santi Heated BZ400 Undersuit is designed to protect the whole body from the cold in a comprehensive manner. The undersuit heats evenly the trunk, thighs and arms. The suit is designed to be worn on top of a thin base layer allowing most of the generated heat to be passed directly to the diver’s body.

Details
SKU 2024.MTM
Options
Gender
Add Connector or Thermovalve
Add Santi 24Ah Battery
£599.00

The made to measure version of the Santi Heated BZ400 Undersuit is designed to protect the whole body from the cold in a comprehensive manner. The undersuit heats evenly the trunk, thighs and arms.

Santi BZ400 Heated SuitThe undersuit is designed to be worn on top of a thin base layer allowing most of the generated heat to be passed directly to the diver’s body.

The Heated SANTI undersuit gives you the best thermal protection under water. It keeps you warm and comfortable while heating even when the batteries are low or completely drained.

New generation of heating wire covered with ultra-soft, silicone isolation resistant to breaking. Innovative, synthetic power cable resistant to high temperatures and cuts.

Works only with Santi Drysuit Connector or Thermovalve. Don’t combine with other connectors or batteries higher than 12V

  • Operating time on 24Ah battery: approx. 2h 30min - 3h
  • Made of BZ400 (420g/m2) Thinsulate™
  • Built in heating glove wires
  • Handy pocket on waist for power cord
  • P-valve hose opening
  • Net cuffs with rubber loops for thumbs
  • Elastic gussets under the armpits
  • Two side pockets
  • Elastic waist band
  • Two way entry zipper
  • Foot straps
  • Maximum heating temperature 45°C
  • Heating power: 110 W
  • Safety switch prevents from overheating
  • Wires covered with ultra-soft silicone resistant to breaking
  • Power cable resistant to high temperatures and cuts
  • Undersuit bag included
  • Mens stock sizes
  • Made to measure option for ladies and men

CHECK:  SANTI SIZE CHART
DOWN LOAD: MADE TO MEASURE FORM
DOWNLOAD: SANTI Sizer Appp


FREE "Made to Fit"
Very few divers require a totally made to measure suit due to the wide range of standard sizes available from manufacturers. With this in mind, Santi offers a free of charge Made-to-Fit service to any standard size suit ordered, sculpting standard suits to a divers' measurements. With your order, you can request up to 4 changes (ranging from 2 to 5 cm) to any of the standard size measurements listed under height, chest, inner arm, biceps, forearm, waist, hips, inner leg, thigh, calf or body trunk on the SANTI size chart.

HOW TO MEASURE YOURSELF
A measuring guide based on the video above.

If you would like to take your own measurements and order your Santi undersuit through us, it is essential to follow SANTI's instructions to avoid any potential mistake in measuring.

Never take your own measurements yourself – they should be taken by another person to make sure all measurements are tight and at correct levels. After you have your measurements taken, please go through them at least twice to ensure nothing is missing or incorrect. Once we receive your M-to-M order we will go through it here, then email you back all details to verify the information before proceeding with the order.

  • Stand straight and do not bend over while you are being measured.
  • It is important to take the measurements only wearing thin clothing, close to the body.
  • Follow the instruction point by point as the measurements taken incorrectly may influence the final fit of the drysuit or undersuit
  • Use only a tailor measurement tape that has centimeters scale (only use metric with cm)
  • Don’t leave any additional measurement allowance – measure as close to the body as possible.
  • Use Santi MADE TO MEASURE FORM to make sure all measurements are completed.
  • Following instruction leads you through the measurement proces also shown in our movie step by step.

HEAD  - approximately 1cm above the eyebrows to choose the correct hood size.

NECK - above the t-shirt line, under the Adam’s apple and the end of the neck.

BODY TRUNK - hold one end of the tape on the central point of the neck end and lead the tape across the crotch to the back. Mark the place where tape ends and measure the rest of the line to the spine neck bone. Make sure the tape is close to the body including all the curves.

SHOULDER TO SHOULDER - back shoulders length from one top arm bone to another.

OUTER ARM LENGHT - from the back neck spine bone to the wrist while the arm is fully stretched.

INSIDE ARM LENGHT - from armpit to wrist.

LADIES ONLY / SIDE TRUNK LENGHT - from the armpit to the waist line.

BICEPS - widest point on the loose arm. If you have a visibly athletic figure it is advised to measure the biceps also with bent elbow.

FOREARM - in the widest point.

WRIST - between the palm and the wrist bone.

CHEST - first measure the chest in rest and then after breathing in air. Normally the difference should be around 3-5cm. For ladies measure in the fullest point of the bust, preferably while wearing a bra.

WAIST - measure on the belly button level. Remember to measure the waist line in the widest point on the belly button line. To measure a female waistline correctly, use any kind of marker belt and fasten it around the waist line.

LADIES ONLY / BACK HEIGHT - centrally from the neck spine bone to the waist line marked with the belt.

LADIES ONLY / CHEST HEIGHT - from the soft neck area (where the neck ends) to the bust line in the fullest point.

HIPS -  in the fullest point of the buttocks.

THIGH - widest point approximately 5cm from the crotch area.

CROTCH TO KNEE - from crotch to knee.

CROTCH TO FLOOR - hold one end of the measurement tape in a convenient place in the crotch and measure to the heel end.

CALF 1 - measure the calf in the widest point.

CALF 2 - height from the widest point of the calf to the floor.

CALF 3 - measure the calf 20cm from the floor.

ANKLE - measure the ankle on the ankle bone.

FOOT - place the tape on the floor and step on it.

 

 

Santi Connectors


SANTI DRYSUIT CONNECTOR

Santi Drysuit ConnectorSanti Drysuit Connector is used with your existing drysuit inflation valve.

Once your standard drysuit inflator valve is removed, the Santi Drysuit Connector is placed and secured in the drysuit valve hole. The cables run through the connector. The existing drysuit inflation valve is then screwed on top of the connector. Select Si-Tech or Apeks as the diameter will be different.

E/O cord connector passes through a standard suit inflation valve and provides power connection from the external battery to a heated product under the drysuit.

  • Available with Apeks or Si-Tech thread size
  • Unit hight 19mm + standard drysuit inflator
  • Total length of the cables including 55cm
  • Works with power supply no higher than 12V


SANTI THERMOVALVE

Santi ThermovalveThe Santi Thermovalve completely replaces your exsisting drysuit inflation valve.

Unlike the Santi Drysuit Connector, it offers two functions in one device: drysuit inflation valve with an integrated connector for Santi heating systems. Select Si-Tech or Apeks as the diameter will be different.

The 90° moveable valve head provides convenient hose attachment which allows for optimal E/O cord and pressure hose settlement under the drysuit.

  • Includes E/O Blind Plug
  • Available with Apeks or Si-Tech thread size
  • Unit hight 29mm
  • Total length of the cables 55cm
  • Works with power supply no higher than 12V


SANTI 24AH BATTERY

Santi 24Ah BatteryThe Santi 24Ah Battery was designed to provide enough power to operate full heated suits. The 24Ah Halcyon | SANTI battery pack is manufactured with hi-tech rechargeable Li-Ion cells which offer high discharge current. As a result, it may be used to supply power to equipment items which require 200W in total.

On the top section of the canister there are an E/O cord connector, piezo switch, overpressure valve. There is also a belt loop (no need for clamps) on the side of the housing.

The battery is designed to supply power to SANTI Heating Systems including undersuits, vests and gloves. However it may be also used with Halcyon Primary Diving Lights.

  • Height: 27cm / Diameter: 7.4cm / Weight: 1.8kg
  • E/O cord length: 35cm
  • Charging time: 14 hours
  • Operation depth: 100m
  • E/O cord connector with unique led illumination
  • Piezo switch
  • Belt loop (no need for clamps)
  • Operating voltage: 12V
  • Material: polyacetal, POM, Delrin
  • Charger included
Operating times:
  • Santi Heated Undersuit: 2hrs 30min - 3hrs
  • Santi Heated Vest: 5 - 6hrs
  • Santi Heated Gloves: 9 - 10hrs
  • Santi Undersuit + Gloves: 2hrs - 2hrs 15min
  • Santi Vest + Gloves: 3hrs 15min - 3hrs 45min


SANTI Heating Systems Explained

SANTI Heating Systems

 

: *
: *
: *
 
Gift certificates

 
We use cookies to give you a better experience and understand how the site is used. By continuing to use this site, you consent to this policy. You can change your preferences any time. Click to learn more.