Apeks WTX Tek Mesh Pocket

The vertical and compact Apeks WTX Tek mesh pocket can be mounted on any standard 2 inch harness (waist) webbing thanks to a loop on the back or attached directly to an Apeks large pocket with 4 rear grommets.

With a bellow construction that allows ample volume the pocket is near-flat when empty yet big enough to store a spare mask and spool or DSMB/spool combination all held securely in place with a pinch clip closure on 1” webbing.

Dimensions of the Apeks WTX mesh pocket are 250 x 135 x 15 (flat outer) 230 x 135 x 70 maximum pocket inner size.

Top Features:

• The pocket flap is secured with a side-release clip.
• Bellow construction allows ample volume.
• Mesh material allows for water drainage and sand flushing.
• 4 rear grommets allow the pocket to attach directly to the WTX harness waistband using hardware kit  p/n 388018.
• Wide, web loop on the back allows it to slide over standard two inch waistband webbing.

Made out of 1050D Ballistic Nylon & V-Diamond Rubber the mesh material of this pocket will allow water drainage.

Apeks WTX Pockets

The Apeks WTX and WTX-D Series is a selection of harnesses, buoyancy cells and accessories which offer unparalleled versatility due to the modular nature of the whole system. Each component can be configured into a highly technical rig for those trained to push the limits, or scaled down to make a travel friendly set up suitable for any diver.

A full range of Tek pockets have been designed by Apeks to complement the WTX range. They can be attached to your WTX system or any other BC/Wing and/or drysuit. The system is modular so you can attach one pocket to the other if space is at a premium. A separate stainless steel hardware kit is available for this.

The Mesh Pocket itself can be fit to the front of the Large Cargo Pocket or directly to the WTX harness. It is an excellent size for carrying surface marker buoys or a spare mask.